Bodywork

    I finally started doing some bodywork.  The first project I tackled was to make the front valance fit around the intercooler.  The intercooler is pushed as far forward as possible to give the maximum amount of space possible in the engine compartment, because of this the valance had to be reshaped slightly to fit around the end tanks near the turn signals.  I also had to modify the center brace that supports the grill, valance and trim piece.  I still need to do a lot of straightening of the valance, it was in a minor accident and is not even close to the right shape yet.

It's a very slow start, but at least I did finally start on it.  I'll keep this page updated as I progress.

(home) (back)